Stainless steel eccentric reducer is also known as stainless steel eccentric reducer, reducing joint, etc. compared with stainless steel concentric reducer, the two centers of eccentric reducer are not on the same line. Eccentric reducers will have a straight edge and a beveled edge. Straight edges are placed above or below for different purposes.
Stainless steel eccentric reducer (stainless steel eccentric reducer) production process also adopts the tube blank with the same outer diameter of the big end pipe, calculates the blanking length, cuts the material, and puts it into the molding mold. Press radial pressing to form the required eccentric reducer, larger diameter can be pressed many times, but the cost is relatively high.
Stainless steel eccentric reducer (stainless steel eccentric reducer) in the pipeline that will produce gas, the gas is lighter than the liquid and will accumulate upward, so we need to put the straight side of the eccentric reducer toward the upper part of the pipeline. This can prevent the phenomenon of gas cannot be discharged. If there are impurities and liquid accumulation in the pipeline, the side with straight edge needs to be at the bottom of the pipe. This can prevent these impurities or effusion can not be discharged phenomenon.
